Considering a DIY Interior Paint Job?

 May 11, 2020 LaTasha Beal

There are a lot of people tackling DIY projects at the moment. Some of these are necessary projects that people are doing themselves to avoid bringing strangers into their homes. Others are simply a way to pass the time and shake off some boredom. Regardless of the reason, you might find yourself considering some interior painting.
This can be a great idea, especially if you find yourself going a bit stir-crazy while you wait for everything to reopen. That said, it’s important that you don’t rush into a DIY painting project since that can lead to results that are less than optimal. Here are a few things to think about to help ensure that your painting project turns out well.

Measure First

A can of paint only goes so far, so it’s important to know just how much paint you need before you buy it. Since most paint colors are mixed, there’s no guarantee that paint mixed at different times will look exactly the same even if it’s all supposed to be the same color. A can of paint covers an average of 400 square feet, though this can differ based on the paint type and other factors. To begin, measure the width and height of each wall and multiply to get their area. Be sure add the area of any ceilings if you’re painting them as well. Once you know exactly how much surface area you need to cover, you can check the coverage of the specific paint you’re getting and buy accordingly.

Make a Single Trip

Even though some areas are opening things up again, that doesn’t mean you can stop respecting social distancing rules. Figure out exactly what you need and make a list so that you can buy it in a single trip. Wear a mask, avoid getting too close to anyone else and go get your supplies at a time when the store isn’t crowded.

Prep Your Rooms

Don’t underestimate the importance of prepping your rooms. Fill any holes, sand rough surfaces and take the time to clean everything. If possible, wash the surfaces you’re going to paint with soap and water a day or two before you plan to start painting. Even if you aren’t painting them, you should also clean the ceiling, baseboards and any other surfaces so that any cobwebs, dust and dirt on them doesn’t mess up your freshly painted surfaces. Remove any outlet covers, light switch panels and anything else that’s attached to the walls. Once the room is ready, be sure and use an appropriate primer to coat everything you’re going to paint before you start painting.

Paint in the Proper Order

You might be tempted to jump right in and start working on the walls. Doing so can actually make things more difficult in the long run, though. If you’re painting your baseboards, start with them first. Move on to window and door frames, then the ceiling. Once these are all painted, give them plenty of time to dry, then put easy-release painter’s tape over the painted surfaces. After everything is taped up, you can then paint the walls and not have to worry about getting paint on those areas you’ve already painted. Any paint that got on the walls while you were painting your trim and ceilings will be painted over with your wall paint.

Working With Tape

Putting down painter’s tape is easy but pulling it up can be very frustrating. A lot of people don’t think about the fact that paint from the walls will overlap onto the tape, so pulling the tape off can take paint with it, leaving an uneven edge on the paint. Before pulling, take a utility knife and cut the paint right at the edge of your trim or taped surface. Pull the tape at a 45-degree angle behind where you’re cutting, ensuring a nice crisp edge to your painting. Just make sure that the paint has dried for at least a day so that it’s not still soft or gummy.

Give Yourself Time

When you start painting, allow yourself at least a few days per room. You’ll need time to prep the surfaces you’re going to paint, time for the primer to dry and then additional time for the paint itself to dry. If you’re doing multiple coats, that time will be even longer. It will all pay off in the end, though, with the extra time resulting in a more professional look with even coverage and nice clean edges. Once everything’s dried you can start replacing anything you removed, but give yourself at least a few more days before trying to clean the newly-painted surfaces.